HotZone Wall Mount Outdoor Electric Patio Heater


MODEL: HZE-1500W - Sale Price $382.00

THE HOTTEST AND ONLY TRUE SPOT HEATER ON THE MARKET!
With a HotZone outdoor wall mount electric patio heater, you can cozy up your patio and enjoy the outdoors longer with targeted spot heating from Schaefer Ventilation.
Spot heat an area up to 8 feet in diameter when mounted 8 feet high.
Warm people and objects and not the air in between, making them ideal for drafty areas and external use. Economical and easy to set up!

  • Patented IR Lens increases output 3 to 5 times versus conventional heaters.
  • ETL certified electric heater.
  • Durable, weatherproof casing.
  • 9 foot grounded cord included.
  • Wall mount with on/off switch.
  • No open flames or carbon monoxide emissions.
  • Quiet and odorless heat. No venting required.
  • Minimal clearance requirements.
  • Pedestal model available. Model: HZE-1500P
  • Made in U.S.A.

HotZone Pedestal Outdoor Electric Patio Heater

MODEL: HZE-1500P - Sale Price $497.00

THE HOTTEST AND ONLY TRUE SPOT HEATER ON THE MARKET!


With a HotZone outdoor pedestal electric patio heater, you can cozy up your patio and enjoy the outdoors longer with targeted spot heating from Schaefer Ventilation.

Spot heat an area up to 8 feet in diameter when mounted 8 feet high.

Warm people and objects and not the air in between, making them ideal for drafty areas and external use. Economical and easy to set up!

  • Patented IR Lens increases output 3 to 5 times versus conventional heaters.
  • ETL certified electric heater.
  • Durable, weatherproof casing.
  • 15 foot grounded cord included.
  • On/off switch and tip switch.
  • No open flames or carbon monoxide emissions.
  • Quiet and odorless heat. No venting required.
  • Minimal clearance requirements.
  • Wall mount model available. Model: HZE-1500W
  • Made in U.S.A.
The outside of the heater is cool - safe for portable applications.

In-Ceiling HotZone TM

Radiant Optics has 3 ways to mount your 1500W and 3000W electric spot heaters in your well ventilated ceilings (when you have enough air space above and around the heater and ventilation to handle the convective heating.)


HOT ZONE DROP MOUNT BEZEL
HOT ZONE FLUSH MOUNT BEZEL



Notes:
  1. Drop bezels taper from back to front. Width dimension is for back of bezel.
  2. Large cavity height is needed to provide adequate clearance from combustibles. Cavity size can be reduced if cavity is lined with concrete board on all sides. Cavity must be well ventilated with a minimum of 6 square inches of vent area per 1500 watt heater, level with or above the heater, to allow hot air to escape.
  3. Minimum mounting height determined by minimum distance to combustibles below heater.
  4. At typical mounting height, temperature affect is approximately +30 degrees at beam center.
  5. Ceiling cutout must be large enough to mount heaters with adequate cumbustible clearance and small enough to be masked (covered) by the bezels.
  6. Recessed reflector (RR) and recessed bezel (RB). Dimensions provided are for bezel shown on previous page. Dimensions for bezel made with T-bar material are 23 1/2 " x 23 1/2 " x 8". Minimum cavity size is unchanged. Ceiling cutout is 22 3/4" x 22 3/4 ".